To address the creation of new products that trend seek

• No.2000-C
• [JIS]P-8113-98, T-494om-01
• [TAPPI]
• [ISO]24-Feb

This tester holds both sides of the test specimen and pulls it at a constant speed, to determine the maximum load up to failure and the elongation at failure, and the work required for failure. When a specimen is inserted into this constant-rate-elongation machine, it is secured by two pneumatic clamps, then the test starts automatically. The load cell connected to the fixed side clamp detects load, to calculate, display and outputs on the printer the tensile strength, elongation, breaking length, tensile energy and tensile stiffness.

• No.2000-CW
• [JIS]
• [TAPPI]
• [ISO]

A specially designed wetting water supply device is mounted on the standard horizontal tensile tester. Dropping water from a dispenser, you can easily measure the wet tensile strength with this machine. Immediately after water in the dispenser is dropped on the specimen, the tensile test is performed. The amount of wetting water and the timing of test start after water dropping can be set as desired.

• No.2001
• [JIS]
• [TAPPI]
• [ISO]

A constant-speed loading type tensile tester. This machine applies a tensile load onto the specimen at a constant speed, to measure the maximum load and elongation at breaking.
One end of the specimen is fixed with the clamp connected to the pendulum, and the other end is secured by the clamp that moves downward at a constant speed.
The test specimen is tensioned at a constant speed, while the load increases. When the specimen breaks, the pendulum stops, and the machine indicates the maximum load and elongation at breaking. The tensile strength is expressed in Newtons, and the elongation in millimeters or ratio (percentage) to the specimen length (180mm). Since the machine is provided with a stepless speed change motor, the tension speed can be changed as desired. The lower clamp is lowered and lifted by the push button. So you can easily perform tension, stop and resetting. When the lower clamp reaches the lowest point, the machine stops automatically to ensure safety.
J.TAPPI No.18

• No.2010
• [JIS]
• [TAPPI]40(1) 1957
• [ISO]

This machine determines rupture stress by rapid tensioning. An impact is given to the specimen slackened to measure the energy loss at rupture. This test determines resistance of continuous paper against break on a rotary printing machine where a large tension may occur instantaneously. It also measures the dynamic strength of bags made of kraft paper in use. This tester is provided with a pendulum to measure the work of rupture of specimens. A test piece 15mm wide and 180mm long is held with the gripper, and the pendulum is lifted to the specified position and released. The specimen is broken at a maximum tension, and the work in N?m (kgf?cm) is shown on the scale.